Table of Contents
Advertisement
How Do I...
External Finishers Available on the Xerox Nuvera System
There are a number of DFA-compliant inline finishers that can be installed on the system. You must
have a DS3500/XPS installed to add a 3rd party finisher. Here is a list of some of the finishers available.
• C.P. Bourg BDFNx Booklet Maker
• C.P. Bourg 3202 Perfect Binder
• GBC Fusion Punch 2 with Offset Stacker
• GBC AdvancedPunch Pro
• Xerox Manual and Book Factory
• Xerox Tape Binder
• Power Square 224 Booklet Maker
• Xerox Dual Mode Sheet Feeder (BSFEx)
What is DFA?
Document Finishing Architecture (DFA) is a set of published specifications that allow finisher vendors
to develop in-line devices that are compatible with Xerox printing equipment. The DS3500/XPS is a
DFA-compliant device.
DFA Configurations and Profiles
A set of default DFA profiles are preinstalled on the system for each DFA-compliant finisher attached
to the Xerox Nuvera System. Generally, the DFA profile is supplied by the finisher vendor and installed
at the time of the finisher installation.
Managing DFA Configurations and Profiles
To switch to a different DFA configuration on your system, refer to
3rd Party
Finishers.
Refer to your System Administrator on how to create, edit, enable/disable, and delete DFA Profiles and
Configurations.
Select the 3rd Party External Finisher as the output device
After you have set up the basic print sections of your job and the System Administrator has defined and
enabled the finisher configuration and profile for your system, perform the following steps to use the
DS3500/XPS and select the finishing output at the user interface.
1. From the Copy Service, Print From File Service or Job Properties window of an inactive job, select the
Output tab.
2. Select the Stapling/Finishing FAB.
3. When printing to a 3rd party finisher, make sure the Output Location pull-down menu is set to System
Specified.
4. From the Stapling/Finishing pull-down menu, select External. All available finishing profiles display.
5. From the profile list that displays, select the profile. The profile name displays in the Stapling/Finishing
pull-down list. To enable or disable profiles, contact your system administrator.
6. Select all other finishing attributes.
7. Click Apply or OK.
14-22
Changing DFA Configurations for
User Guide and Training Aid (UGTA)
Xerox
®
Nuvera
®
Advertisement
Table of Contents
