ADIC Scalar Reference Manual page 82

Table 4-25 Rule Event Location Areas
Entry
Send notification if event is
related to the following device
To be notified about a specific
error situation for an event
The Rule Notification Sent dialog continues the wizard process. The way to send notification should
be specified here.
Figure 4-24 Rule Notification Sent Dialog
Refer to table below for the definitions.
Table 4-26 Rule Notification Sent Areas
Entry
How should the
notification be delivered
After this notification is
acknowledged, do you
want a ticket to be
generated
Next
Although there exist some predefined rules that send notification via SNMP, the
NOTE:
user-created rules other than predefined cannot deliver SNMP notification
because of interface properties.
The Notification Receiver dialog pane identifies the user who receives the notification.
4-22
Operation
Select Client selection. Refer to
4-17.
Enter An error code listing. Refer to
page 7-7
Operation
Select EMAIL sends notification via email.
GUI sends a notification to the Management GUI.
Check Enable/disable a service ticket generation request
(enable only when GUI selected).
Click If EMAIL is selected, the Rule Email Destination
dialog appears. See
If GUI is selected, the Rule Notification Receiver
dialog appears. See
Scalar DLC
Description
Table 4-22 on page
Error Codes on
and Table 4-22 on page
Description
Figure 4-26 on page
Figure 4-25 on page
4-17.
4-23.
4-23.
6-00658-02