ADIC Scalar Reference Manual page 223

Scalar DLC
Immediately after the Scalar DLC software and the Target drivers are installed, the SCSI Target
ports can be disabled. To make them operational, enable the ports via the SCSI Target Port tool.
Enable only the ports that should operate in Target mode. An attempt
CAUTION:
to use the Initiator port as a Target may cause a system crash (for
example, if the hard disk is connected to the adapter, its port must
work in Initiator mode.
Do not use two adapters of the same model in different operation modes
NOTE:
(Initiator and Target). Otherwise, it is possible to make a mistake and enable an
Initiator as a Target.
After disabling the SCSI Target Port, launch the Device Manager and enable the SCSI port as an
Initiator. Restart the system afterwards. Enabling a SCSI port as a Target can be done via the SCSI
Target Port tool (a reboot may be required).
Figure 6-8 SCSI Target Port Tool
Table 6-7 SCSI Target Port Tool
List Operation
Port list Select
Refresh Click
Enable Click
Disable Click
Advanced Click
Exit Click
Port is the port full name.
Type is a port type.
Status is a port status (enabled/disabled).
Refresh the port list.
Enable the disabled SCSI Target port.
Disable the enabled SCSI Target port.
Advanced port parameters (only for Fibre Channel ports). See
Figure 6-9 on page 6-10.
Close the SCSI Target Port Tool.
Description
6-9