Display Volsers Of The Optical Disk (Getvoltoside; Display Connected Host Software Type (Hosttype; Table B-24 Parameters For The Getvolsertodrive Command; Table B-25 Parameters For The Getvoltoside Command - ADIC Scalar Reference Manual

The assignment is configured in Scalar DLC Management GUI, via Cartridge Properties pane.
Refer to Cartridge on page
See below an explanation of the parameter for the getvolsertodrive command.
Table B-24 Parameters for the Getvolsertodrive Command
Parameter
drive drive whose volsers are to be displayed, for example, Drive1.

Display Volsers of the Optical Disk (getvoltoside)

The getvoltoside command displays both volsers for an optical disk.
dasadmin getvoltoside volser
See below an explanation of the parameter for the getvotoside command.
Table B-25 Parameters for the Getvoltoside Command
Parameter
volser one of the volsers for the optical disk, the associated sides of which are to be
displayed, for example, OD001A.

Display Connected Host Software Type (hosttype)

The hosttype command gets information about connected host software type (AMU or SDLC).
dasadmin hosttype
HostType: SDLC
Status : READY
Text : SDLC version V2.5.0005
See below an explanation of the returned information for the hosttype command.
Table B-26 Returned information for Hosttype Command
Parameter
HostType returned hosttype
AMU
SDLC
Status returned status of host (bitwise field)
PAUSE ACI_HOST_PAUSED - the host currently is in PAUSE mode (refer to
READY the DAS is ready
Text the command can return some additional information about host (like version or
build number).
B-18
5-26.
AMU system
Scalar DLC system
Pause DAS Communication (pausedas) on page
Explanation
Explanation
Explanation
Scalar DLC
B-35)
6-00658-02