Scsi - ADIC Scalar Reference Manual

Scalar DLC
Table 5-53 DAS Client Creation Properties and Buttons
Property/Button Icon
Check I/E Area
Names
Avoid Media
Identifier
Contention
Requires Drive
Allocation
Priority
Sequence
Wait insert before
mount
Command pause
Drive pause
Create
Cancel
Help
If a firewall exists between the client host and the Scalar DLC, under the client
NOTE:
host name, specify the DAS/ACI firewall PC name. Refer to Installation Guide,
Installing DAS Client section.
The new DAS Client is functional immediately after creation. No supervisor
NOTE:
restart is required.

SCSI

All the operations with the SCSI Clients are enabled only after the configuration of SCSI Target
software. That can be done via the SCSI Target tab. Refer to
Configuration Tab
Operation
Don't The I/E (mailbox) area names that can be used by the
check client are not limited with the DAS naming standard.
Check Cartridge media identifiers are shown only as a result of
executing a cartridge information operation.
Don't A client does not need to allocate the drive slot before
check executing a mount or dismount.
Select Low means the client-sent commands have the lowest
priority in a queue. Refer to
Medium means the client-sent commands have the
standard priority in a queue. Refer to
page 5-97.
High means the client-sent commands have the highest
priority in a queue. Refer to
Don't A commands sent by client without sequence option will
check be executed as they are ready. The system will not wait
until the previous client command is finished.
Don't A client without wait insert option cannot wait until the
check ejected cartridge will be inserted for the mount could be
executed.
Don't A client without command pause privilege is not
check authorized to execute "pausedas" DAS command.
Don't A client without drive pause privilege is not authorized
check to execute "pausedrive" DAS command.
Click Create client.
Click Cancel creation.
Click Open online help for the current pane.
Description
Queue Tab on page
Queue Tab on
Queue Tab on page
SCSI Target Tab on page
5-97.
5-97.
5-87.
5-73