Reserve Volsers (Allocv; Table B-6 Parameters For The Allocd Command; Table B-7 Parameters For The Allocv Command - ADIC Scalar Reference Manual

The explanation of the parameters for the allocd command follows.
Table B-6 Parameters for the Allocd Command
Parameter
drive drive whose status is to be changed.
UP, FUP, new reservation status.
EXUP,
UP
DOWN,
FUP
FDOWN
EXUP
DOWN
FDOWN
client name
SHARED_ACCESS
This function is used in the management of drives with shared usage. Only one client can use a
drive at a time. Mount and dismount commands issued by other clients are rejected. A drive must
be released by its previous user before another client can normally use it.
The drive can only be put in the DOWN status by FDOWN if the drive is
NOTE:
occupied.
Also, refer to Display Drive Assignment (listd3) on page

Reserve Volsers (allocv)

The allocv command reserves the specified volser(s) for a client.
dasadmin allocv volserrange UP client
dasadmin allocv DOWN client
See below a list and an explanation of the parameters for the allocv command.
Table B-7 Parameters for the Allocv Command
Parameter
volserrange range of volsers to be reserved.
UP, DOWN new reservation status.
UP
DOWN
client name of client under which the reservation is to be made.
B-8
normal reservation of empty drive.
reserve a drive even if it is already reserved by another
client or occupied.
exclusive reservation, can only be undone by the client
himself or by DAS_SUPERVISOR.
remove the normal status of a reservation from empty
drive.
remove reservation even if the drive is reserved by
another client or occupied.
change reservation status for the client.
change reservation status for all clients.
reserves the specified volser/volsers.
removes the reservation of all volsers for the client.
Explanation
B-28.
Explanation
Scalar DLC
6-00658-02