ADIC Scalar Reference Manual page 68

Table 4-10 Select Client Areas
Name Operation
Select the type Select
of new Client
Name of new Enter
Client
The next dialog is Configuration Summary. See figure below.
Figure 4-9 Configuration Summary
Review the configuration summary before creating the library configuration. Refer to table below.
Table 4-11 Configuration Summary Areas
Name Operation
Summary Supplied
The final configuration dialog then appears.
4-8
DAS Client creates the DAS client with all parameters by
default. Always available if the DAS Client support is installed.
SCSI Client creates the SCSI Client assigned to the first free
LUN of the first existing Target. Available only after the SCSI is
configured (at least one target is created and at least one LUN
is free). Refer to Create Target on page 5-94
on page 5-95.
ROBAR Client selects the ROBAR Client. Available only after
the ROBAR interface is configured (non-zero port is specified).
Refer to ROBAR on page
Enter the name of the new client.
Be sure that the data entered from the previous dialogs is
correct.
Scalar DLC
Description
and
5-83.
Description
Create LUN
6-00658-02