Next Scratch Medium (Scr_Get; Scratch Pool Information (Scr_Info - ADIC Scalar Reference Manual

Table B-63 Parameters for the Scop Command
Parameter
ip-addr temporarily changes the client's authorized IP address; the address must be
specified in the form xxx.xxx.xxx.xxx, for example, 192.131.23.10 or as an
internet hostname. The parameter must be specified with the first scop
command or in the event of changes to the IP address.
Client specifies the client to which the changes refer:
+ access privileges assigned to new client
- access privileges withdrawn from client
access privileges or operating parameters of an existing client are changed if ±
is omitted
The changes will be lost when the DAS software is shut down. It is best
CAUTION:
to make changes via the Scalar DLC Management GUI.

Next Scratch Medium (scr_get)

The scr_get command queries the next available scratch medium and sets it to unscratch.
dasadmin scr_get [poolname] [-t media-type]
See below a list and an explanation of the parameters for the scr_get command.
Table B-64 Parameters for the Scr_get Command
Parameter
poolname specification of the pool name in the Scalar DLC database from which the
scratch medium is to be taken.
media-type required scratch cartridge media type, for example, 3590. Refer to
on page
The media-type parameter must always be set. This is the required parameter.
NOTE:

Scratch Pool Information (scr_info)

The scr_info command provides information on the current stock of scratch media in the scratch
pools.
dasadmin scr_info [poolname] [-t media-type]
Information on the default scratch pool can be obtained by specifying the media type without the
pool name.
See below a list and an explanation of the parameters for the scr_info command.
B-42
A-9.
Explanation
Explanation
Scalar DLC
Media Types
6-00658-02