Display Drive Assignment (Listd5 - ADIC Scalar Reference Manual

Scalar DLC
dasadmin list CLIENT
list for client: CLIENT successful
client = CLIENT
request = 1
individ_no = 0
type = PINV
client = CLIENT
request = 7
individ_no = 0
type = MONT
See below an explanation of the return status associated with the list command.
Table B-34 Explanation of Returned Status for List Command
Display
client client for which the active commands are to be displayed.
request sequence number of the DAS commands
individ_no not used
type MONT
KEEP
INVT
MOVE
PINV
SHUT
INCL
EJCL
BACO
This command is supported for compatibility reasons. It is limited to only a small
NOTE:
number of commands. Use the list3 command instead.

Display Drive Assignment (listd5)

The listd5 command displays the current drive assignment and status of reservations by the clients.
If the drive is not specified, all drives assigned for the client will be displayed. All drives (maximum
nSize) will be displayed if a client is not specified.
This command was introduced to support long drive names and show drive pause mode.
dasadmin listd5 nSize [clientname] [-d drivename]
dasadmin ld5 nSize [clientname] [-d drivename]
See below a list and an explanation of the parameters for the listd5 command.
Commands Overview
Explanation
mount command
dismount command
insert command
eject command
inventory/partinventory command
Scalar DLC shut down (killamu)
Insert Clean
Eject Clean
Barcode on/off
B-25