Reserve Drive (Allocd - ADIC Scalar Reference Manual

Scalar DLC
Table B-4 DAS Management Commands
Command
barcode activates/deactivates the library barcode reader for the mount, carry, and eject
commands.
cancel deletes a command from the command queue.
email sends the message via email.
hosttype provides information about the type of the connected host
killamu terminates Scalar DLC software and OS.
list displays the DAS command queue.
list2 displays the advanced DAS command queue.
list3 provides enhanced information on executing requests
pausedas turns dasadmin to a passive state.
pausedrive logically turns a tape drive disable/enable.
qversion displays the DAS and ACI version.
robhome makes the library system inactive.
robstat makes the library system active or queries status.
rpctest perform quick portmapper test
shutdown shuts down Scalar DLC
snmp sends the message via SNMP.
switch switches between active and passive cluster nodes.
Table B-5 Scratch Management Commands
Command
scr_get displays the next available scratch volser from the scratch pool.
scr_info displays information relating to the scratch pool.
scr_insert inserts a cartridge and adds it to the scratch pool.
scr_mount places the next available scratch cartridge in the drive.
scr_set adds cartridges in the library system to the scratch pool.
scr_unset changes cartridge status from scratch to unscratch.
The configuration of scratch pools, clean pools, and insert/eject areas should be
NOTE:
executed via the Scalar DLC Management GUI. The configuration of Define
Range and Reserve Range can be done from both Management GUI and client
side as well.

Reserve Drive (allocd)

The allocd command changes the reservation status of a drive for a client.
dasadmin allocd drive UP|EXUP|FUP|DOWN|FDOWN client
dasadmin all drive UP|EXUP|FUP|DOWN|FDOWN client
Commands Overview
Explanation
Explanation
B-7