Table of Contents
Advertisement
Scalar DLC
Add Media to the Scratch Pool (scr_set_range)
The scr_set_range command adds a volserrange to a scratch pool in the Scalar DLC database.
This makes scratch media available for subsequent scr_get and scr_mount commands.
dasadmin scr_set_range [poolname] [-t media-type] volserrange
Data stored on media may be lost. This command automatically sets the
NOTE:
specified medium as a scratch medium without a confirmation prompt. The data
on the data medium is overwritten by the next scratch mount command.
See below a list and an explanation of the parameters for the scr_set_range command.
Table B-69
Parameters for the Scr_set_range Command
Parameter
poolname
specification of the pool name in the Scalar DLC database to which the scratch
medium is to be added.
media-type
required scratch cartridge media type, for example, 3590. Refer to
on page
volserrange
volserrange to become the scratch media.
The media-type parameter must always be set. This is the required parameter.
NOTE:
This will be created in the Scalar DLC database if the specified pool name does not exist. The
default scratch pool name will be used, for example, DEFAULTV1, if no scratch pool name is
specified.
This command will be rejected with the message EOTHERPOOL if the medium
NOTE:
already exists in another scratch pool.
Remove Medium from Scratch Pool (scr_unset)
The scr_unset command sets the medium specified by the volser to unscratch in the Scalar DLC
database and removes the volser from the scratch pool. A scratch pool will be deleted when the last
volser has been removed from the scratch pool.
dasadmin scr_unset [poolname] [-t media-type] volser
See below a list and an explanation of the parameters for the scr_unset command.
Table B-70
Parameters for the Scr_unset Command
Parameter
poolname
specification of the pool name in the Scalar DLC database from which the
scratch medium is to be removed.
Commands Overview
A-9.
Explanation
Explanation
Media Types
B-45
Advertisement
Table of Contents
Troubleshooting
