Cluster License; Figure 6-37 Finishing License - ADIC Scalar Reference Manual

Figure 6-37 Finishing License
When the license is installed, the tape device must be online. Otherwise, the
NOTE:
license will not be applied.
After the license string is installed restart the Scalar DLC supervisor
CAUTION:
for the changes take effect.

Cluster License

Although there is no license wizard for Scalar DLC Cluster solution, there is a special sequence to
install the license for the cluster.
Step 1 Start Scalar DLC software on Node1. Request the license. Refer to
on page 6-21.
Step 2 Send the license request file to ADIC customer support. The authorizarion string
(string1) will be returned.
Step 3 Change the active node to Node2. Request the license here as well. Refer to
Obtaining License on page
Step 4 Send the license request file to ADIC customer support. The authorizarion string
(string2, different from string1) will be returned.
Step 5 Register the license on Node1 with the string1. Refer to
6-24. Take the Scalar DLC supervisor offline, so the active node will be changed to
Node2.
Step 6 Register the license on Node2 with the string2. Refer to
6-24. Take the Scalar DLC supervisor offline, so the active node will be changed back
to Node1.
6-26
6-21.
Scalar DLC
Obtaining License
Installing License on page
Installing License on page
6-00658-02