Table of Contents
Advertisement
G4-508HD4a User Manual & Install Guide
Configuring the G4-508HD4a
display,
recording
and
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow you
§
to select any combination of the camera
channels to be included in the display
and recording.
Post Recording – drop list which allows
§
you to select the duration for which video
will continue to be recorded when the
alarm is triggered.
Lock – checkbox, if selected will mark the
§
recorded video associated with this
alarm as locked video.
3G Network – checkbox, if selected will
§
enable alarm notification over the 3G
network.
Linkage IO Output – checkboxes, if
§
enabled, the device will send a signal to
the selected IO output lines.
Output Delay Time – numeric text field
§
to set the delay time for the IO output (in
seconds).
Alarm Upload – checkbox, if selected will
§
enable the device to upload the alarm to
the center server.
Linkage Screen – drop list to select the
§
options to display the video from the
selected cameras on-screen when the
alarm occurs.
None : Not displayed.
Single : Display 1 camera.
Quad : Display 4 cameras.
If Single (1x1) or Quad (2x2) display is
selected, the ( Setup ) button allows
you to select the layout of the channels
to be displayed on-screen.
The drop lists are shown on-screen
accordingly to the grid layout mode
selected. You can easily choose each
individual
camera
displayed in the selected grid segment
visually. If you have less cameras than
available grid segments, then those
snapshot
options
channel
to
be
121 of 162
Advertisement
Table of Contents
