Table of Contents
Advertisement
G4-508HD4a User Manual & Install Guide
IGNITION
POSITIVE
Sensor Cable
The sensor cable CAB000356 connects to the DB26 connector marked "SERIAL" on the back of the
§
device. The sensor portion of the cable is 5 metres sheathed together. Wires are colour coded and
labelled with its corresponding Sensor number.
There is a 4 pin flat Molex connector for attaching a Driver Alert Button or Alert Panel.
§
The second 2 pin Molex connector is used for connection a Zoom Camera to the recorder.
§
ICD
The ICD connector is used to connect an optional ICD2 touch screen panel to the device. The panel
§
can be used for configuring the recorder, configuring the IP cameras viewing live video and playing
back video. CAB000391 is used to connect the ICD Panel to the recorder.
GPS
If this option is included, a GPS module must be installed and a 5 GHz antenna must be attached to
§
imbed the vehicle location and speed into the video.
Amplifier
The amplifier connector is used to connect the fan wire.
§
Hardware Installation
Typically, grounds are established in the fuse panel, and installers
would need to connect there.
(B) (Yellow)
Connect to the vehicle ignition, +12V, signal required to
activate the device. Ensure that the provided 3 AMP
fuse is used. Ignition is obtained from the "cold" side
of the solenoid.
(C) (Red)
Connect to the positive terminal of the battery, +12v.
Ensure that the provided 15 AMP inline fuse is used. +12V is
obtained from the "hot" side of the solenoid, or the cables that
connect directly to the battery from the fuse panel
149 of 162
Advertisement
Table of Contents
