Table of Contents
Advertisement
G4-508HD4a User Manual & Install Guide
Main Stream
Basic System Quick Start
Pre-Recording
Channel Name
Enable
Resolution
DEFAULT SETTINGS:
Checkbox – Unselected
§
DEFAULT SETTINGS:
Channel 1 – set name as – CH1
§
Channel 2 – set name as – CH2
§
Channel 3 – set name as – CH3
§
Channel 4 – set name as – CH4
§
Channel 5 – set name as – CH5
§
Channel 6 – set name as – CH6
§
Channel 7 – set name as – CH7
§
Channel 8 – set name as – CH8
§
Channel 9 – set name as – CH9
§
Channel 10 – set name as – CH10
§
Channel 11 – set name as – CH11
§
Channel 12 – set name as – CH12
§
The device comes pre-configured with standard
names for the camera channels. You may change
these names if desired to give each channel an
easily remembered and/or location-specific
name.
Maximum of: 5 characters
Notes:
-
Channels 1 to 8 are Analog/Analog HD
channels.
-
Channels 9 to 12 are Digital IP camera
channels.
For channels 1 to 8, only enable the channels
which actually have cameras connected. Please
note that the system will show a videoloss
message on channels which are enabled, but do
not have a connected camera (i.e., no incoming
video stream).
Likewise, for channels 9 to 12 (which are Digital IP
Camera channels), only enable the channels
which actually have cameras connected.
DEFAULT SETTINGS:
For channels 1 to 8 (Analog camera channels), set
the following:
D1
§
For Analog HD cameras set these to 720p
44 of 162
Advertisement
Table of Contents
