Table of Contents
Advertisement
G4-508HD4a User Manual & Install Guide
Panel Alarm
Configuring the G4-508HD4a
Panic
Linkage IO Output – checkboxes, if
§
enabled, the device will send a signal to
the selected IO output lines.
Output Delay Time – numeric text field
§
to set the delay time for the IO output (in
seconds).
Alarm Upload – checkbox, if selected will
§
enable the device to upload the alarm to
the center server.
Linkage Screen – drop list to select the
§
options to display the video from the
selected cameras on-screen when the
alarm occurs.
None : Not displayed.
Single : Display 1 camera.
Quad : Display 4 cameras.
If Single (1x1) or Quad (2x2) display is
selected, the ( Setup ) button allows
you to select the layout of the channels
to be displayed on-screen.
The drop lists are shown on-screen
accordingly to the grid layout mode
selected. You can easily choose each
individual
camera
displayed in the selected grid segment
visually. If you have less cameras than
available grid segments, then those
segments associated with an actual
camera will be displayed as a black box
PB Alarm Duration – numeric text field
§
to set the duration of the video playback
(in seconds) when the alarm occurs.
Alarm Snap – checkbox – if selected,
§
when the alarm occurs, the device will
take snap shots using the selected
cameras.
DEFAULT SETTINGS:
Unchecked
Checkbox – if selected, enables the device to
monitor for panel alarm trigger. In case of the
panic button on the panel being pressed, this
alarm will be triggered.
channel
to
be
119 of 162
Advertisement
Table of Contents
