Instructions For Setting Up The System; Figure 9-1 4 Port Switch (12V Poe) - Gatekeeper G4-508HD4a User Manual & Installation Manual

Table of Contents

Advertisement

G4-508HD4a User Manual & Install Guide
9.3

Instructions for Setting Up the System

The device is capable of recording up to 8 analog and 4 digital cameras simultaneously. The 8 analog cameras
are plugged into the back of the recorder using the camera cables and 8 camera DB44 to Molex adapter cable,
CAB000373. Each camera connector on the cable is marked with its corresponding camera number (AVIN1 –
AVIN8).
4 Port Switch
The Digital IP cameras must be connected to the device using the 4 Port Camera Switch provided by
Gatekeeper Systems.
The switch is powered using the power cable provided with the switch (CAB000384).
§
Plug the connector marked "SWITCH" into the front DC connector on the front of the Switch.
§
The "OUTPUT" connector plugs into the DC connector on the device.
§
The "INPUT" connector attaches to the power cable CAB000359 or CAB000360.
§
Using a CAB000367, connect the LAN connection on the device to the connector on the Switch.
§
If you need to connect the device to the network while all 4 camera plugs are populated, connect a
§
CAT 5 cable to the Uplink connector on the front of the Switch.
Up to a maximum of 4 IP cameras can be plugged in at one time. Each IP camera is plugged into one
§
of the ports (CAM1-CAM4) on the back of the Switch.
There are 7 indicator lights on the front of the Switch.
When active, the lights will flash green except the PWR light which will be solid.
Installing Cameras
Up to 8 analog cameras can be connected to the device. These are connected to the DVR using
§
CAB000373. The maximum current draw for all 8 cameras cannot exceed 3 Amps.
Up to 4 digital IP cameras can be installed. The cameras are plugged into the 4 port switch.
§
Serial
CAB000356 is connected to the Serial port on the device.
§
Hardware Installation

Figure 9-1 4 Port Switch (12V POE)

DVR
: indicates Switch has connectivity to 508HD4
CAM1-CAM4
: indicates active camera on that port
Uplink : indicates a signal is being sent thru the uplink
PWR
: indicates the Switch is powered on
150 of 162

Advertisement

Table of Contents
loading

Table of Contents