Table of Contents
Advertisement
G4-508HD4a User Manual & Install Guide
9.5
Camera Mounting and Connections
General Considerations
Camera mounting locations are to be determined by the customer/client.
§
Cameras should be mounted to the ceiling whenever possible. Install the rubber pad provided with
§
each camera and cut a small notch in the rubber pad to accommodate the camera cable. The audio
hole on the front of the camera can be used as an aiming guide for the direction the camera needs to
be facing.
All camera harnesses must be carefully routed to the DVR unit to avoid pinching or piercing the
§
shielded camera cable.
All cables running through holes in sheet metal (ceiling, bulkhead, etc) must be protected with
§
grommets.
Ensure included gasket is in place between dome base plate and mounting surface.
§
When installing multiple cameras, mark camera harness wires so the school district knows which
camera is front and back by looking at the marked Molex output connectors.
Important Notes
Routing the Camera Harness (GSWHC2N-XX):
Always use grommets when running the harness through sheet metal
§
holes.
Avoid excessively tight bends especially around metal surfaces.
§
Coil and tie off excess harness in a safe place.
§
DO NOT disassemble the Camera Ball unless directed to, and under
the supervision of an authorised Gatekeeper Systems support
technician.
Camera Body Parts
A
: Rubber Gasket
B
: Base Plate
B1
: Cut Out Notches
C
: Camera Ball
D
: Camera Collar
E
: Retainer Ring
Hardware Installation
157 of 162
Advertisement
Table of Contents
