Setting Monitoring Functions - Dräger Julian Operating Instructions Manual

Monitoring
Configuring During Operation

Setting Monitoring Functions

Select »settings« column by turning dial knob,
press to confirm.
Display (example):
Setting volume of the pulse tone
0 = off
9 = maximum volume
Select the line »pulse tone« by turning dial knob,
press to confirm. The cursor automatically jumps to
the last value selected (example: 5).
Adjust value with dial knob, press to confirm.
Setting audible alarm volume
1 = minimum volume
9 = maximum volume
Select the line »alarm sound« by turning dial knob,
press to confirm. The cursor automatically jumps to
the last value selected (example: 4).
Adjust value with dial knob, press to confirm.
WARNING !
Always set audible alarm volume to a level
that is sufficiently loud with respect to the
general noise level of the surroundings.
NOTE: Local standards require a volume of at least
45 dB(A) for audible alarms. Therefore, settings
1 through 4 are configured to deliver this audio level.
Selecting the scale
For scaling volumeter function and trend trace.
Select the line »scale« with dial knob,
press to confirm.
Select »adult« or »child« with dial knob,
press to confirm.
78
CMV
MAC-config. alarms calibration
PAW
O
MAC display default
40
2
21 Vol.%
on off
CO on off
2
gas sensor
MAC correction
SpO on off
2
on off
20
age 36
HLM on off
FiCO 5
2
0
Fresh Gas O + N O
2 2
P V
max T
O % L/min cmH O mL
2
2
50 1.00 25 600 10
settings
-Sensor
pulse tone 0 1 2 3 4 5 6 7 8 9
alarm sound 1 2 3 4 5 6 7 8 9
scale adult child
parameters
record
activate monitor defaults
T :T
Freq. T :T PEEP
IP I
I E
bpm % cmH O
2
1:2.0 10 0