Dräger Julian Operating Instructions Manual page 79

Setting the measuring parameters
Select the line »parameters« with dial knob,
press to confirm.
The »parameters« menu appears in the left-hand
field.
Display (example):
Switch SpO measurement (optional) on/off:
2
Select the line »SpO measurement« with dial knob,
2
press to confirm.
Select »on« or »off« with dial knob,
press to confirm.
Select sample rate for gas measurement:
Select the line »sample rate« with dial knob,
press to confirm.
Select »60« or »200 mL/min« with dial knob,
press to confirm.
Recommendation: select 200 mL/min.
Select CO units of measurement:
2
Select the line »CO unit« with dial knob,
2
press to confirm. The last value selected is
highlighted by a gray background.
Select desired units of measurement by turning
dial knob, press to confirm.
Setting pressure unit:
Select the line »Pressure unit« by turning the rotary
knob and press to confirm.
Select »Pa*100« or »mbar« or »cmH
the rotary knob and press to confirm.
Setting flow display:
Select the line »Flow display« by turning the rotary
knob and press to confirm.
Select »MV« or »Vt« by turning the rotary knob and
press to confirm. The selected parameter is displayed
on the standard page. Vt alarm limits are not
monitored. The alarm limits set for MV continue to be
monitored in operation.
CMV
anesth. agent
PAW
40
SpO
Sample rate
20
CO
CO
Pressure unit
0
Volume display
Configuration Menu for Measurement Parameters.
Fresh Gas O + N O
O %
2
50
O« by turning
2
Configuring During Operation
alarms calibration settings
pls. tone
alarm sound
measurement on off
2
scale
parameter
60 200 mL/min
record
activate monitor defaults
unit mmHg kPa %vol.
2
scale 0-75 0-110 mmHg
2
Pa*100 mbar cmH 0
2
MV Vt
2 2
P V Freq.
max T
L/min cmH O mL bpm
2
1.00 25 600 10
Monitoring
0 1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
adult child
T :T T :T PEEP
IP I
I E
% cmH O
2
1:2.0 10 0
79