Setting Volume Of The Pulse Tone (Optional); Setting Audible Alarm Volume; Selecting The Scale - Dräger Julian Operating Instructions Manual

Turn dial knob to select digits consecutively from the
line provided and press to confirm. The password is
indicated underneath with asterisks ( * * * * ).
The menu for selecting default settings appears when
the password has been entered correctly.
Display (example):

Setting Volume of the Pulse Tone (Optional)

0 = off
9 = maximum volume
Select the line »pulse tone« by turning dial knob,
press to confirm. The cursor automatically jumps to
the last value selected (example: 5).
Adjust value with dial knob, press to confirm.

Setting Audible Alarm Volume

1 = minimum volume
9 = maximum volume
Select the line »alarm sound« by turning dial knob,
press to confirm. The cursor automatically jumps to
the last value selected (example: 4).
Adjust value with the dial knob, press to confirm.
O2 FAILURE and GAS FAILURE (O
will always be signaled with maxium volume, indepen-
dent of the current alarm sound setting.
WARNING !
Always set audible alarm volume to a level
that is sufficiently loud with respect to the
general noise level of the surroundings.
NOTE: Local standards require a volume of at least
45 dB(A) for audible alarms. Therefore, settings
1 through 4 are configured to deliver this audio level.

Selecting the Scale

To adapt a default scale for the volumeter function
and trend trace.
Select the line »scale« with dial knob,
press to confirm.
Select »adult« or »infant« with dial knob,
press to confirm.
Standby / Configuration
MAC-config.
MAC display
on
MAC correction
on
age
and Air failure)
2
Configuring in Standby Mode
Setting Default Values
defaults
calibration
pls. tone
O -sensor
2
21 vol.% alarm sound
off
scale
gas
parameter
sensor
off
record
more
interface
36
alarm limits
curves
basic configurations
CMV settings
PCV settings
Fresh Gas Flow Control
0 1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
adult child
93