Show Software Version; Disclaimer; Service, Repair; Decommissioning, Disposal - MICRO-EPSILON optoCONTROL 2600 Operating Instructions Manual

Measure
optoCONTROL 2600
6.9

Show Software Version

Retrieve the current firmware version in the Service menu.
1
Art, Vers.
C
Boot: STD 1004
1 ARM : STD 1014
DSP : TLZ 1016
1
or ESC key to leave the menu.
Press the
7.

Disclaimer

All components of the device have been checked and tested for functionality in the
factory. However, should any defects occur despite careful quality control, these shall be
reported immediately to MICRO-EPSILON or to your distributor / retailer.
MICRO-EPSILON undertakes no liability whatsoever for damage, loss or costs caused by
or related in any way to the product, in particular consequential damage, e.g., due to
- non-observance of these instructions/this manual,
- improper use or improper handling (in particular due to improper installation,
commissioning, operation and maintenance) of the product,
- repairs or modifications by third parties,
- the use of force or other handling by unqualified persons.
This limitation of liability also applies to defects resulting from normal wear and tear (e.g.,
to wearing parts) and in the event of non-compliance with the specified maintenance
intervals (if applicable).
MICRO-EPSILON is exclusively responsible for repairs.
It is not permitted to make unauthorized structural and / or technical modifications or
alterations to the product.
In the interest of further development, MICRO-EPSILON reserves the right to modify the
design.
In addition, the General Terms of Business of MICRO-EPSILON shall apply, which can
be accessed under Legal details | Micro-Epsilon
sum/.
For translations into other languages, the German version shall prevail.
8.

Service, Repair

In the event of a defect in the controller, light
source, receiver or the sensor cable please
send us the affected parts for repair or ex-
change.
In the cause of a fault cannot be clearly identi-
fied, please send the entire measuring system
to
9.

Decommissioning, Disposal

Remove the power supply and output cable on the controller.
Remove the sensor cable between light source, receiver and controller.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging ma-
terials in compliance with the applicable country-specific waste treatment and disposal
regulations of the region of use.
https://www.micro-epsilon.com/impres-
MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
Tel. +49 (0) 7161 / 98872-300
Fax +49 (0) 7161 / 98872-303
eltrotec@micro-epsilon.com
www.micro-epsilon.com
Page 61