A 5.6 Editing The Measurement Program - MICRO-EPSILON optoCONTROL 2600 Operating Instructions Manual

Appendix | Operating Menu
A 5.6 Editing the Measurement Program
The program selected before is template for editing.
edit
program
name: USER1
type: MULTISEG
ESC
1)
1)
1)
1)
1)
2)
Fig. 71 Operating menu Editing the Measurement Program
1) These menu points cannot be selected and processed with the Multi-segment measurement program, because
their contents are not used. Analog output = 0 VDC.
The function zero-setting / mastering cannot be executed.
2) The limit output of the Multi-segment measurement program differs from the other standard programs. For the
segment 1 + 2 one upper and one lower limit can be defined.
optoCONTROL 2600
Window only appears if
a segment program has
been previously
selected
edit
segment
S1 S2
1.K 1 3
2.K 2 4
enter value
for master
value not
saved
enter offset
for display
enter factor
for display
enter offset
for
analog output
enter factor
for
analog output
enter upper
warning limit
Window only appears if
a multi-segment
program has been
previously selected
2
Number of to
be measured
Amount of
segments
segments
master value
+00.0000 mm
new value in
main memory
press for 3 sec.
display offset
+00.0000 mm
display gain
+1.0000
analog offset
+00.0000 VDC
analog gain
+1.0000
high warning
(HW)
+040.0000 mm
Produce segment
program
3
4
press briefly
for one
place further
Page 76