Danfoss VLT MCD 600 Operating Manual page 112

VLT® Soft Starter MCD 600
Operating Guide
Option Function
Read Only
Prevents users altering parameter values in the Main Menu.
Parameter values can still be viewed.
Table 168: 10-8 - User Parameter 1
Option
Blank
* Current
Motor Voltage
P1 Voltage
P2 Voltage
P3 Voltage
Mains Frequency
Motor pf
Motor Power
Motor Temp (%)
Hours Run
Number of Starts
Pump Pressure
Pump Flow
Well Depth
Pump Temperature
Analog Output Value
Heat Sink Temperature
Bypass Model (%)
SCR Temperature
Rating Capacity (%)
Table 169: 10-9 - User Parameter 2
Option
108 | Danfoss A/S © 2020.12
Function
Selects which information is shown on the main monitoring screen.
Shows no data in the selected area, allowing long messages to be shown without overlapping.
Average rms current across all 3 phases.
Average rms voltage across all 3 phases.
Phase 1 voltage.
Phase 2 voltage.
Phase 3 voltage.
The average frequency measured on 3 phases.
The motor's power factor, measured by the soft starter.
The motor's running power in kW.
The motor's temperature, calculated by the thermal model.
The number of hours the motor has run via the soft starter.
The number of starts the soft starter has completed since the start counter was last reset.
The pressure at the pump, as configured in parameters 30-2 to 30-4. This information is only availa-
ble if the smart card is installed.
The flow at the pump, as configured in parameters 30-6 to 30-11. This information is only available if
the smart card is installed.
The depth of the well, as configured in parameters 30-13 to 30-15. This information is only available
if the smart card is installed.
The pump temperature, as measured by the PT100. This information is only available if the smart
card is installed.
The value of the analog output (see parameter group 9-** Analog Output).
The soft starter's temperature measured at the heat sink.
The percentage of thermal capacity remaining in the bypass contactor.
The temperature of the SCRs calculated by the thermal model.
The thermal capacity available in the soft starter for its next start.
Function
Selects which information is shown on the main monitoring screen.
See parameter 10-8 User Parameter 1 for details.
Programmable Parameters
AQ262141844215en-000401 / 175R1174