Lcp And Feedback; Local Lcp And Feedback; Remote Lcp - Danfoss VLT MCD 600 Operating Manual
Soft starter
Hide thumbs
Also See for VLT MCD 600:
- Operating manual (146 pages) ,
- Installation manual (36 pages) ,
- Installation manual (8 pages)
Table of Contents
Advertisement
VLT® Soft Starter MCD 600
Operating Guide
8 LCP and Feedback
8.1 Local LCP and Feedback
1
READY
RUN
2
3
Back
Reset
Illustration 24: Local LCP
1
Four-line display for status and programming de-
tails.
2
Status LEDs.
1
•
Back/Reset: Exit the menu or parameter, or cancel a parameter change. This key also resets a trip.
•
Menu/Store: Enter a menu or parameter, or save a parameter change.
•
Arrows: Scroll to the next or previous menu or parameter, change the setting of the current parameter, or scroll through the status screens.
8.2 Remote LCP
The remote LCP can be used to control the soft starter if parameter 1-1 Command Source is set to Remote Keypad.
•
If the remote LCP is not selected as the command source, [Start], [Stop], and [Reset] have no effect.
•
The menu navigation keys and display on the remote LCP are always active.
•
If a key is pressed on the local LCP, the display on the remote LCP updates to match.
The remote LCP can be safely connected or removed while the soft starter is running. It is not necessary to remove mains or
control voltage.
56 | Danfoss A/S © 2020.12
TRIP
LOCAL
Menu
Store
N O T I C E
3
Menu navigation keys
AQ262141844215en-000401 / 175R1174
LCP and Feedback
(1)
Advertisement
Table of Contents
