SEH myUTN utnserver Pro User Manual page 104

USB Deviceserver User Manual macOS
Table 8.3-1: Parameter list – IPv4
Parameters
ip_addr
[IP address]
ip_pfxlen
(Prefix length]
ip_router
[Router]
ip_dhcp
[DHCP]
ip_auto
[ARP/PING]
We recommend deactivating DHCP, BOOTP and ARP/PING as soon as the UTN server
has been assigned with an IP address.
Value Default
valid IP address 169.254.0.0/
16
valid IP address 255.255.0.0
valid IP address 0.0.0.0
on/off on
on/off on
Description
IP address of the UTN server.
The IP address and the prefix length defines the
network mask of the UTN server.
Subnet masks are used to logically partition big
networks into subnetworks. If you are using the
UTN server in a subnetwork, it requires the sub-
net mask of the subnetwork.
IP address of the network's standard router
which the UTN server uses.
With a router, you can address IP addresses from
other networks.
Enables/disables the DHCP protocol.
If DHCP is enabled in your network, IPv4 net-
work configuration (IP address, subnet mask,
gateway, DNS) is automatic.
Enables/disables the ARP/PING protocol.
You can use the commands ARP and PING to
change an IP address. The implementation
depends on your system; read the documenta-
tion of your operating system.
100
Appendix