Honda BF40D Manual page 408

20) Set the power tilt motor wire and the trim angle sensor wire
in the motor wire bushing.
21) Install the motor wire bushing on the L. stern bracket
aligning the projection on the motor wire bushing with the
recess in the L. stern bracket.
Check that the power tilt motor wire and the trim angle
sensor wire on the backside of the L. stern bracket are not
slack.
22) Clamp the power tilt motor wire and the trim angle sensor
wire at the taped part using the wire harness clip.
Clamp the wires with care not to pinch the spiral tube.
23) Check the anode metal for corrosion. Replace the anode
metal with a new one if it is corroded excessively.
24) Set the 116 mm lead wire between the projections on the
anode metal as shown, and install the anode metal by
tightening the two 6 x 23 mm flange bolts.
25) Set the 116 mm lead wire as shown, and tighten the 6 x 8
mm screw securely.
13-31
[2]
WIRE
[1]
HARNESS
SPIRAL
CLIP
TUBE
[9]
TAPE
[8]
TRIM ANGLE
SENSOR WIRE
[1]
ANODE METAL
6 x 23 (2)
[3]
116 mm LEAD WIRE
[4]
6 x 23
PROJECTIONS
[3] 116 mm LEAD WIRE
408
[3]
L. STERN BRACKET
[4]
PROJECTION
[5]
MOTOR
WIRE
BUSHING
[6]
RECESS
[7]
POWER TILT
MOTOR WIRE
[2]
6 x 8 mm
SCREW
[2]
6 x 8 mm SCREW
[3] 116 mm LEAD WIRE