Gam-Gamma Control - Christie CineLife+ 4 Series Technical Reference

Commands
Command Description
FCS? Returns the current motor position and direction.
(Read-only)
FCS <position> Moves the lens mount to a specified focus position with
a specified direction.
FCS+MOVR <step> Moves the motor a given number of steps relative to
the current location.
FCS+STOP Stops the motor.
FCS+STRT Starts the motor moving in a specified direction.
Examples
Return current motor position and direction:
(FCS?)
Move lens to position 500 at focus motor with a positive approach:
(FCS 500 1)
Move lens to position 500 at focus motor with a negative approach:
(FCS 500 -1)
Move the motor 200 steps in a positive direction:
(FCS+MOVR 200)
Move the motor 100 steps in a negative direction:
(FCS+MOVR -100)
Stop the motor:
(FCS+STOP)
Start the motor moving in a positive direction:
(FCS+STRT 1)
GAM–Gamma Control
Gets or sets the gamma file, which describes the gamma response curve for the source signal.
Parameters
• Access level: Installer
• Power level (minimum): Power Up
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
CineLife+ serial commands
Values
—
position = Numeric value
step = Numeric value
—
-1 = Negative approach
1 = Positive approach
11