Table of Contents
Advertisement
Turn the projector on and the light source off:
(PWR 0)
Turn on the projector and light source:
(PWR 1)
Set the projector to standby mode:
(PWR 3)
Return the time remaining (in seconds) for cooling down mode:
(PWR+COOL?)
Return the projector power status:
(PWR+STAT?)
SHU–Shutter
Opens and closes the shutter.
Parameters
•
Access level: Operator
•
Power level (minimum): Power Up
Commands
Command
Description
SHU?
Gets the state of the shutter. (Read-only)
SHU <0 | 1>
Opens or closes the shutter.
Examples
Get the state of the shutter:
(SHU?)
Result:
(SHU!0)
Indicates the shutter is open.
Open the shutter:
(SHU 0)
Close the shutter:
(SHU 1)
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
CineLife+
serial commands
Values
—
0 = Opens the shutter
1 = Closes the shutter
25
Advertisement
Table of Contents
