Table of Contents
Advertisement
Examples
Display the current logged in user and their access level:
(UID?)
Log out the current user:
(UID)
Log in as service:
(UID "service" "<password>")
ZOM–Lens Zoom Position Adjustment
Sets the lens zoom.
In most cases the active lens is specified by the current channel. If a user selects a different lens file
in the ILS File Setup panel of the user interface, the selected lens file becomes active. This file may be
different from the one specified by the current channel.
Parameters
•
Access Level: Operator
•
Power level (minimum): Power Up
Commands
Command
ZOM?
ZOM <position> <-1 | 1>
ZOM+MOVR <step>
ZOM+STOP
ZOM+STRT <-1 | 1>
Examples
Return current Zoom motor position and direction:
(ZOM?)
Move Zoom to position 500 with a positive approach:
(ZOM 500 1)
Move Zoom to position 500 with a negative approach:
(ZOM 500 -1)
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
Returns the current zoom motor position and
direction. (Read-only)
Moves the lens mount to a specified zoom
position.
Moves the motor a given number of steps based
on the current location.
Stops the motor.
Starts the motor moving in a specified direction.
™
CineLife+
serial commands
Values
position = Numeric value
step = Numeric value
—
-1 = Negative approach
1 = Positive approach
30
Advertisement
Table of Contents
