Pinion Bearing; Propeller Shaft Bearing Housing And Forward Gear - "O" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

Slide the propeller shaft onto the shift shaft, align

the hole in the shaft with the hole in the clutch

dog, install the pin and then, a new clutch dog

retaining spring. Place three coils over each end

of the pin, MAKING SURE NONE OF THE COILS

OVERLAP OR ARE LOOSE.

1. Retaining spring

Pinion Bearing

Refer to Pinion Bearing Installation on p. 285.

Propeller Shaft Bearing Housing

and Forward Gear – "O" Type

Remove and discard the bearing housing O-ring.

Remove the anode and discard if more than two-

thirds deteriorated.

Clamp the bearing housing by the anode bosses

in a vise, as shown. Remove the forward gear

assembly by unscrewing it with Spanner Wrench,

GEARCASE – COUNTER ROTATION

SHIFTER, BEARING AND SEAL SERVICING

Remove gear housing retaining ring.

Remove the set screws and remove the flange.

Remove the shim from either the flange or forward

Table of Contents