Propeller Shaft Bearing Housing And Gear Installation - "S2" And "O" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
Apply Gasket Sealing Compound to the threads of
the driveshaft bearing housing screws. Tighten
screws in stages to a torque of 120 to 144 in. lbs.
(13.5 to 16.5 N·m).
1
1. Driveshaft bearing housing screws
Use Driveshaft Holding Socket, P/N 311875, Pin-
ion Nut Holder, P/N 334455,
Retainer, P/N 341438, to tighten the pinion nut to
a torque of 100 to 110 ft. lbs. (136 to 149 N·m).
Pad handle of holder to prevent damage to gear-
case.
1
1. Holding socket
2. Pinion holder
3. Retainer
302
Propeller Shaft Bearing Housing
and Gear Installation – "S2" and
"O" Type
The propeller shaft bearing housing on these
models SLIDES in or out of gearcase housing.
Oil and install thrust bearing and thrust washer on
hub of reverse gear. Slide the gear assembly onto
the propeller shaft until it engages the pinion gear.
1
2
COA3153
and Wrench
1. Thrust bearing
2. Thrust washer
Lightly apply Gasket Sealing Compound to a new
bearing housing O-ring. Install O-ring in groove in
the housing.
Install housing into gearcase. Align screw holes
with retainer slots in gearcase.
Housing must be completely seated to install
retainer tabs.
3
2
42229
Retainer Tab Slot
1
DSC02295
50106a