Oiling System Tests; Oil Injection Pump Static Test; Oil Injection Pump Voltage Tests - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

OILING SYSTEM TESTS

IMPORTANT:
Always perform visual inspections
to identify oiling system leaks. Make sure the oil
tank is filled and oil supply is not contaminated.

Oil Injection Pump Static Test

The EMM controls the pump by providing ground
through pin 23 (blue wire) of the J1-B connector
and pin 2 (blue wire) of the oil pump connector.
Use Evinrude Diagnostics software to activate the
Oil Injector test. This test starts the EMM control
function for the oil injection pump.
1
Static Tests Screen
1. Oil injector test button
IMPORTANT:
This test is operating the pump
with 30 V on the system voltage (55 V) circuit. The
start assist circuit (SAC) of the EMM converts bat-
tery voltage (12 V) to 30 V of system voltage. Bat-
tery must be fully charged and connections must
be clean and tight. Pump activation should be
carefully confirmed. Listen for an audible click
from the oil injection pump when it is activated.
Use an inductive timing light to monitor current
flow through the ground circuit (blue wire) at the
oil pump connector (pin 2).
If the light flashes, the EMM and oil injection cir-
cuits are not at fault.
Refer to Oil Injection Pump Voltage Tests on
p. 175.

Oil Injection Pump Voltage Tests

Use a digital multimeter calibrated to a scale that
reads 55 V (DC) to measure voltage between the
oil pump electrical connector and engine ground.
Acceptable Oil Injection Pump
Key switch ON
Control signal
Engine running
Connect negative meter lead to ground.
Use an appropriate test probe to connect positive
meter lead to pin 2 (blue wire) of oil injection pump
electrical connector.
1
008116
1. Oil injection pump connector (pin 2)
Turn the key switch to the ON position. Observe
voltage at pin 2.
•
Voltage at pin 2 should be approximately 30 V.
Use the Oil Injector test of Evinrude Diagnostic
software Static Test screen to activate the oil
pump.
1
Static Tests Screen
1. Oil injector test button
OILING SYSTEM
OILING SYSTEM TESTS
Test Readings
approximately 30 VDC
approximately 10 Hz
approximately 55 VDC
8
005442
008116
175