Shift Rod Cover; Pinion Gear And Driveshaft Installation; Propeller Shaft Bearing Housing And Gear Installation - "O" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

GEARCASE – COUNTER ROTATION
GEARCASE ASSEMBLY

Shift Rod Cover

Refer to Shift Rod Housing Installation on
p. 296.
Pinion Gear and Driveshaft
Installation
Refer to Pinion Gear and Driveshaft Installation
– "O", "L2", and "M2" Type on p. 301.
Propeller Shaft Bearing
Housing and Gear Installation –
"O" Type
Lightly apply Gasket Sealing Compound to a new
bearing housing O-ring. Install O-ring in groove in
the housing.
Install housing into gearcase. Align screw holes
with retainer slots in gearcase.
IMPORTANT:
The propeller shaft must engage
the clutch shaft and the forward gear must fully
engage the pinion gear.
322
Housing must be completely seated to install
retainer tabs.
Retainer Tab Notch
Install two retainers, washers and screws. Apply
Ultra Lock to threads and tighten screws to a
torque of 18 to 20 ft. lbs. (24 to 27 N·m).
1. Retainer tab screws
Loosen retainer screws 1/4 turn.
Install wedge, screw, and washer. Apply Ultra
Lock to threads and tighten screw to a torque of
13586
15 to 20 in. lbs. (1.7 to 2.3 N·m).
50106a
1
001989
DSM02291
DSC02361