GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
Install pinion gear in gearcase housing
Install driveshaft with thrust bearing, thrust
washer, and correct shim(s) in gearcase housing.
Position pinion on lower driveshaft.
Position pinion screw in lower driveshaft and
thread into pinion.
298
IMPORTANT:
ing for support during pinion tightening procedure.
005420
Insert Lower Driveshaft Spline Tool, P/N 5007052,
into lower driveshaft.
1
1. Lower Driveshaft Spline Tool
005410
Insert Lower Driveshaft Wrench, P/N 352877,
through Lower Driveshaft Spline Tool and lower
driveshaft. Seat hex tip of wrench in head of pin-
ion screw.
005421
1. Wrench, hex tip
Temporarily install bearing hous-
005426
005407
1
005408