Propeller Shaft Bearing Housing And Gear Installation - "L2" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Install two retainers, washers and screws. Apply
Ultra Lock to threads and tighten screws to a
torque of 18 to 20 ft. lbs. (24 to 27 N·m).
1. Retainer tab screws
Loosen retainer screws 1/4 turn.
Install wedge, screw, and washer. Apply Ultra
Lock to threads and tighten screw to a torque of
15 to 20 in. lbs. (1.7 to 2.3 N·m).
Re-tighten two retainer screws to 18 to 20 ft. lbs.
(24 to 27 N·m).
Confirm that torque on the wedge screw is 15 to
20 in. lbs. (1.7 to 2.3 N·m).
GEARCASE – STANDARD ROTATION
Propeller Shaft Bearing Housing
and Gear Installation – "L2" Type
IMPORTANT:
ing on the "L2" type gearcases is PRESSED into
the gearcase housing.
1
Oil and install thrust bearing and thrust washer on
hub of reverse gear.
2
001989
1. Thrust bearing
2. Thrust washer
Slide the gear assembly onto the propeller shaft
until it engages the pinion gear.
1
DSM02291
DSC02361
1. Thrust bearing and thrust washer
Lightly apply Triple Guard Grease to a new bear-
ing housing O-ring. Install O-ring in groove in the
housing. Grease the machined side surfaces of
bearing housing.
GEARCASE ASSEMBLY
The propeller shaft bearing hous-
1
006905
006843
12
303