Intake Manifold Service - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Tighten screws in stages, starting with the lower
screw.
•
First torque is 5 ft. lbs. (7 N·m)
•
Second torque is 10 ft. lbs. (14 N·m)
•
Final torque is 24 to 26 ft. lbs. (33 to 35 N·m).
Tighten Screws in Stages
Reconnect fuel injector/coil electrical connectors.
Install fuel manifolds. Refer to Fuel Manifold Ser-
vice on p. 149.
FUEL COMPONENT SERVICING

Intake Manifold Service

Removal
Disconnect vapor separator vent hose, throttle
position sensor connector, and throttle link arm.
Use Ball Socket Remover Tool, P/N 342226, to
remove throttle link arm.
Remove crankshaft position sensor from reed
plate assembly.
Remove oil filter from retainer.
Remove oil pump bracket screws.
Remove throttle body screws and throttle body
assembly.
007195
1
1. Throttle body screws (14 on V4, 18 on V6)
Remove gasket from throttle body.
Remove tie straps holding connectors to side of
reed plate assembly.
Remove two screws holding electrical harness
base to reed plate assembly.
1
1. Harness base screws
FUEL SYSTEM
1
7
005368
1
005345
153