Exhaust Housing Assembly - V4 Models - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

EXHAUST HOUSING SERVICE

Cleaning Solvent. Apply Gel-Seal II sealant to the

adapter flange of the exhaust housing.

Place the adapter/inner exhaust housing into the

exhaust housing. Guide the water tube through

the hole in the outer housing.

Apply Triple-Guard grease to threads of adapter

retaining screws. Tighten two forward screws to a

torque of 216 to 240 in. lbs. (24.5 to 27 N·m) and

rear screw to a torque of 60 to 84 in. lbs. (7 to 9.5

1. Adapter retaining screws

Exhaust Housing Assembly –

Install the collar on shaft.

Use a 0.030 in. (0.762 mm) feeler gauge to set the

gap between the collar and exhaust housing as

1. Set gap to 0.030 in. (0.762 mm)

Tighten screw to a torque of 60 to 84 in. lb. (18 to

Chapters

Table of Contents