Propeller Shaft Bearing Housing And Gear Installation - "M2" Type - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Re-tighten two retainer screws to 18 to 20 ft. lbs.
(24 to 27 N·m).
Confirm that torque on the wedge screw is 15 to
20 in. lbs. (1.7 to 2.3 N·m).
Propeller Shaft Bearing
Housing and Gear Installation –
"M2" Type
IMPORTANT:
The propeller shaft bearing hous-
ing on "M2" type gearcases is PRESSED into the
gearcase housing.
Lightly apply Triple Guard Grease to new bearing
housing O-rings. Install O-rings in grooves in the
housing. Grease the machined side surfaces of
bearing housing.
Place bearing housing in gearcase.
Align retaining holes in bearing housing with
screw holes in gearcase. Thread Alignment Pins,
P/N 354140, into gearcase.
1
1. Alignment pins
GEARCASE – COUNTER ROTATION
IMPORTANT:
gears must align properly for bearing housing to
seat properly.
Use Installer Handle, P/N 345822, Propeller Shaft
Bearing Housing Installer, P/N 354057, Gearcase
Fixture, P/N 354059 and an appropriate floor
press (10 ton or greater) to install housing into
gearcase. Align and level gearcase assembly in
fixture as shown. Secure fixture to floor press.
3
4
1
1. Gearcase fixture, P/N 354059
006846
2. Vertical alignment screws
3. Handle P/N 345822
4. Housing installer P/N 354057
Housing must be completely seated in gearcase
to install retainer screws. Bearing housing is
approximately level with gearcase.
1
006926
GEARCASE ASSEMBLY
Pinion, clutch dog and forward
2
006927
12
006928
323