Diagnostic Software Functions; Communication; Static Information - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

ENGINE MANAGEMENT MODULE (EMM)

DIAGNOSTIC SOFTWARE FUNCTIONS

DIAGNOSTIC
SOFTWARE FUNCTIONS
The EMM stores valuable information about the
outboard and its running history. This information
can be used for troubleshooting, for checking
parts information, and for making adjustments to
the system.
Use Evinrude Diagnostics software, version 4.5 or
higher, and a laptop computer to access program
information.
IMPORTANT:
For software help, refer to the
"Help" menu in the software.

Communication

Locate the diagnostic connector on the engine.
Remove the cover and install the Diagnostic Inter-
face Cable (P/N 437955).
1
1. Cover
2. Diagnostic interface cable
3. Engine harness diagnostic connector
Connect the 9-pin connector of the interface cable
directly to the computer's serial port.
The EMM must turn ON before it will communicate
with the computer.
Power is normally supplied to the EMM when the
key switch is ON. Switched B+ (12 V) enters the
EMM at pin 21 (purple) of the EMM J1-B connec-
tor.
The EMM is also turned ON when it begins to
receive AC voltage from the stator while the out-
board is being cranked.
62

Static Information

Static information is viewed when the outboard is
NOT running. This includes manufacturing infor-
mation.
The outboard model and serial numbers displayed
on the Identity screen must match the identifica-
tion label on the outboard swivel bracket.
2
Identity Screen
The serial number and cylinder location displayed
3
on the Injector Coefficients screen must match the
actual cylinder placement for each injector.
005240
Injector Coefficients Screen
008102
008103