Crankshaft Removal - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

NOTICE
Reattach each rod cap to its rod as
soon as the piston is removed. Each cap is
unique and can only be installed on its mated
rod. Do not allow rod to contact inside surface
of cylinder or crankshaft.
IMPORTANT:
Identify all internal components
so that if reused, they can be reinstalled in their
original positions.
Repeat steps for each remaining piston and con-
necting rod.
Use an appropriate ring expander to remove all
piston rings from pistons. Discard the rings.
WARNING
Wear safety glasses to avoid injury.
Remove wrist pin retaining rings. Discard retaining
rings.
The wrist pin fit is loose on both sides. Push the
wrist pin through to free the piston from the con-
necting rod. If necessary, use Wrist Pin Pressing
Tool, P/N 326356, to remove the wrist pin bearing.
Be careful not to lose any of the 28 needle bear-
ings or the two wrist pin washers. If any of the
bearings are worn or lost, replace all 28 bearings
during reassembly.

Crankshaft Removal

WARNING
Wear safety glasses to avoid injury.
Carefully lift crankshaft straight up and remove
from crankcase.
002054
46524
POWERHEAD
POWERHEAD DISASSEMBLY
46520
10
005285
201