Extension Service - V4 Models; Removal; Installation; Stern Bracket - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

EXTENSION SERVICE – V4 MODELS

EXTENSION SERVICE –

Remove six screws retaining extension.

Remove extension.

Remove grommets and seal.

Apply Adhesive 847 to the shift rod and water tube

flange of the extension. Install new grommets.

Apply Triple-Guard grease to outer grommet sur-

Apply Adhesive 847 to the bottom flange of the

extension. Install a new seal.

Apply Triple-Guard grease to outer seal surface.

1. Adhesive 847

2. Triple-Guard grease

Install extension with six screws and tighten to a

torque of 18 to 20 ft lb. (24 to 27 N·m).

Before servicing the stern bracket:

Remove gearcase. Refer to Gearcase GEAR-

CASE REMOVAL AND INSTALLATION on

Remove powerhead. Refer to Powerhead

POWERHEAD REMOVAL on p. 196.

Remove exhaust housing. Refer to Exhaust

Remove power trim/tilt unit. Refer to TRIM AND

TILT section.

Remove and discard steering shaft locknut.

Remove the lower mount bracket and keeper.

Chapters

Table of Contents