Assembly - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

TRIM AND TILT
SERVICING–SINGLE PISTON SYSTEM
Remove drive coupler from either the motor or the
pump assembly.

Assembly

IMPORTANT:
Use only Evinrude/Johnson Bio-
degradable TNT Fluid to fill the hydraulic system.
Install drive coupler in pump assembly.
Install a new motor O-ring.
346
Position the motor on the manifold and install four
new screws and lock washers. Tighten the screws
35 to 50 in. lbs. (4 to 5.6 N·m).
004281
Oil O-rings and install them on the manual release
valve. Oil and install the manual release valve.
Tighten the valve to a torque of 45 to 55 in. lbs.
(5.1 to 6.2 N·m).
Install new retaining ring in groove.
004280
1
1. Retaining ring
004282
004285
004283