Icon Network Connections - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

Advertisement

ROUTINE SERVICE
OUTBOARD RIGGING CONNECTIONS

ICON Network Connections

If the outboard is equipped for an Evinrude ICON
control system, connect the outboard to the net-
work as follows.
Refer to the ICON Remote Control System
Installation Guide.
Connect the buss cable from the rear network hub
to the outboard's network harness.
1. ICON network connector
IMPORTANT:
Do not force connectors or lock-
ing rings. Properly aligned connectors should
assemble easily.
Do not use Electrical Grease on ICON buss cable
connectors.
To assemble the connectors:
Use the large tabs and small tabs to carefully
align buss cable connectors.
Carefully align pins and sockets of connectors.
Do NOT force connectors together.
22
Tighten locking rings of buss connectors finger
tight. Do NOT use locking rings to force connec-
tors together.
1. Large tabs
2. Small tabs
Do not rotate connectors until they align. This
1
could result in a mismatched connection. It is pos-
sible for each pin to enter a socket even if the tabs
are misaligned. Look at the tabs to ensure con-
nector alignment prior to making the connection.
Engine Monitor information is distributed to an
008157
ICON or I-Command network through the ICON
gateway module. Refer to the I-Command Digital
Network Guide.
The ICON Harness and Relay Kit, P/N 765296,
must be used to provide power to boat accesso-
ries that require switched B+. This kit is used in
place of connecting accessories to the "A" termi-
nal of the key switch. Accessories connected to
the accessory power relay should not exceed 7
amps.
NOTICE
Do not connect boat accessories to
the key switch of an ICON system. Connecting
accessories to the key switch can cause low
current, resulting in erratic operation of the
remote control system.
For more information, refer to the ICON Remote
Control System Installation Guide.
1
2
007883

Advertisement

Table of Contents
loading

Table of Contents