Shift Housing Assembly - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

GEARCASE – STANDARD ROTATION

SHIFTER, BEARING AND SEAL SERVICE

Shift Housing Assembly

Clean and inspect all parts before

beginning assembly procedures. Replace any

damaged parts.

Lightly coat the detent ball and spring with Needle

Bearing grease. Insert the spring in the housing,

then the ball.

Insert shifter detent at 90° angle into the housing

as shown, while depressing the ball and spring

with a suitable tool. Once the shifter detent is past

the ball, remove the tool and position detent to

engage NEUTRAL position.

Thoroughly grease 25 needle bearings with Nee-

dle Bearing grease and place in the bearing case.

(Note: "S2" Type has caged roller bearing.)

With shifter detent in NEUTRAL, install arms of

shift lever into detent slots. Align the pivot holes

and insert the retaining pin. Push shifter detent

1. Shifter detent

2. Shift lever

3. Pin, shift lever

Rest the cradle on the shift shaft.

2. Shift shaft

Table of Contents