Throttle Linkage Removal; Shift Linkage Removal; Crankcase Disassembly - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

Throttle Linkage Removal

Remove throttle cam and throttle lever.

1. Throttle cam screw

2. Throttle lever screw

Remove shoulder screw from shift arm and retain-

ing screw from shift rod lever.

1. Shift arm screw

2. Shift lever screw

Slide entire shift linkage assembly from crank-

Use a 1/8 in. diameter pin punch to push crank-

case taper pin toward the front side of the engine.

any other tool that could jam in or damage the

taper bore when removing the pin.

Remove crankcase flange screws.

1. Flange screws (12 on V4; 16 on V6)

Loosen in stages and remove the main bearing

1. Main bearing screws (6 on V4; 8 on V6)

POWERHEAD DISASSEMBLY

Do not use a tapered punch or

Table of Contents