Powerhead Assembly; Crankshaft Assembly - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

Inspect center main bearing and split sleeves for

excess wear, nicks, or scratches. Replace, if nec-

Inspect crankshaft rod bearings for excess wear,

nicks, or scratches. Replace, if necessary.

assemblies unless a pressing operation is called

for. All internal components must be perfectly

clean and lightly coated with outboard lubricant.

gaskets, seals, and O-rings during assembly.

Oil the end of the crankshaft. Use Crankshaft

Bearing/Sleeve Installer, P/N 338647, and place a

new lower main bearing onto crankshaft with let-

tered side facing the tool. Install bearing until it

seats on the crankshaft.

Oil the end of the crankshaft. Use Crankshaft

Bearing/Sleeve Installer, P/N 338647, to drive a

new sleeve onto the crankshaft until the installer

contacts the lower main bearing.

POWERHEAD ASSEMBLY

Proceed slowly. Make no forced

Use new wrist pin retaining rings,

Table of Contents