Shift Linkage Installation - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

POWERHEAD
POWERHEAD ASSEMBLY
Start in the center and work outward in a spiral
pattern.
1
Apply Nut Lock to crankcase flange screws. Install
screws and tighten to a torque of 60 to 84 in. lbs.
(7 to 9.5 N·m).
1
Test that the crankshaft spins freely without bind-
ing.
IMPORTANT:
After
assembled, allow at least two hours for Gel-Seal II
to cure before running outboard.
216
005313
005306
powerhead has been

Shift Linkage Installation

Lubricate shift linkage bosses at the base of the
crankcase with Triple-Guard grease. Insert bush-
ings into bosses.
1
Apply Triple-Guard grease to the shaft of the shift
lever assembly. Guide shaft through bushings in
crankcase.
Apply Triple-Guard grease to shoulder of shift arm
screw and Nut Lock to threads. Install arm, screw,
and washer and tighten screw to a torque of 120
to 144 in. lbs. (13.5 to 16.5 N·m).
Install shift rod lever and tighten retaining screw
60 to 84 in. lbs. (7 to 9.5 N·m).
1
1
1. Shift arm screw
2. Shift lever screw
2
008454