Exhaust Housing Installation - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

Table of Contents

If removed, coat the lower mounts with soapy

water and press into the exhaust housing with the

"OUTSIDE" mark facing outward.

Install the mount covers. Apply Nut Lock to

screws, install washers and screws, and tighten to

a torque of 150 to 180 in. lbs. (17 to 20 N·m).

EXHAUST HOUSING SERVICE

Exhaust Housing Installation

Bring the exhaust housing into position with the

stern bracket.

Install four new lower mount screws with lock-

patch. Tighten screws to a torque of 38 to 45 ft.

lbs. (51 to 61 N·m).

INSTALLATION on p. 219.

Install gearcase. Refer to Gearcase GEARCASE

REMOVAL AND INSTALLATION on p. 268.

Table of Contents