Mounting The Mains Cable - Fronius Trans Pocket 1500 Service Instructions Manual

Mounting the
mains cable
Fig.9
Fig.10
Fig.11
Fig.12
(87)
(34)
(49) (87)
(84) (85) (86)
- Push the mains cable into the housing
(88)
- Wind the mains-cable earthing
conductor (87) onto the ferrite core
(88), with 5 windings
- Carefully pull the mains cable a short
way out of the housing, until the ferrite
core (88) with the wound-on earthing
conductor (87) can be stowed away
well
- At the rear of the machine, tighten the
M5x25 - TX20 screws (34) for the
mains-cable strain relief device with a
torque of 1.5 Nm
- Thread the mains-cable earthing
conductor (87) through the air-guide
film (49) and plug it onto the heat sink
- On the mains leads L - brown (84) and
N - blue (85), push the insulating
sleeves (86) onto the flat-pin plugs
95